Sydney

help... orange triangle

28 posts in this topic

About the actuator I would have unscreved the motor, taken off the rubber cap and sprayed the inside with cleaning spray until the crap runs out the other hole.

Then dry it with compressed air and lube it with plastic friendly lube.

Share this post


Link to post
Share on other sites
46 minutes ago, Norway450 said:

About the actuator I would have unscreved the motor, taken off the rubber cap and sprayed the inside with cleaning spray until the crap runs out the other hole.

Then dry it with compressed air and lube it with plastic friendly lube.

im going to take it apart this weekend and have a look.

Share this post


Link to post
Share on other sites
2 hours ago, Willys said:

Have you tried dissecting it yet...it does come apart and may just need a good clean out and regrease.....the cap is a pain to get back as it was, very small rivits etc but it's possible....not that much to them.

i'll have a look inside this weekend.  i did take apart my other dead actuator.  the teeth on the rotating arm are stripped. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

    Chatbox
    You don't have permission to chat.
    Load More